The battery life of general trucks, construction vehicles and other automobiles is 3 years. If the owner of a vehicle is used properly, it can extend its service life. The fall of autumn, the oil battery should pay attention to maintenance, and today to introduce you to a few points need to pay attention to car oil battery maintenance, allowing you to enjoy a more comfortable and safe driving pleasure.

Battery

According to professionals, although the battery life is generally only 3 years, but if used properly, it can extend its life. First of all, do not exceed 3 seconds each time you start the engine. If the first start fails, do not rush to start it repeatedly. Because continuously starting the motor will cause the battery to be overdischarged and damaged, the time interval for restarting should not be less than 5 seconds. Followed by do not use the CD, cigarette lighter and other electrical equipment when the vehicle is not started. After shutting down, pay attention to turn off lights and other power-consuming components. The sensitivity of the anti-theft device should not be adjusted too high. In addition, when the vehicle is not used for a long time, it should be started once a week to charge the battery, otherwise it will shorten the life of the battery due to self-discharge. In order to avoid a sudden strike of the battery, it is recommended that the replacement battery be replaced as soon as the time limit for replacement is reached. Otherwise, the consequences would be disastrous. If you are in the urban area battery "strike", you can call and rescue; if you are away from the rescue area, once the battery does not work, the cost of long-distance rescue is much higher than the price of one or two batteries. When starting the car, the uninterrupted use of the start-up opportunity causes the battery to be damaged due to excessive discharge. The correct way to use it is that the total length of time for each vehicle is less than 5 seconds, and the interval for starting again is not less than 15 seconds. In the case of a car that has not been started for many times, the cause should be found in other aspects such as a circuit, an ignition coil or an oil circuit.

The battery is an indispensable part of the car. According to the existing battery types in the market, it can be roughly divided into two types: traditional lead-acid batteries and maintenance-free batteries that have been widely used in China in recent years. The following is a description of some issues that need attention when using and maintaining batteries.

The lead-acid battery is composed of positive and negative plates, separators, housings, electrolytes, and wiring pile heads. The chemical reaction of discharge depends on the active material of the positive electrode plate and the active material of the negative electrode plate in the electrolyte (dilute sulfuric acid solution). Next, the grid of the plates is made of lead-antimony alloy. The traditional battery will reduce the liquid during use. This is because the crucible on the grid will contaminate the lead on the negative plate, causing excessive decomposition of the water. A lot of oxygen and hydrogen respectively escape from the positive and negative plates, making electrolysis possible. Reduced fluid. The maintenance-free battery is made of lead-calcium alloy. Since the battery uses a lead-calcium alloy grid, the amount of water decomposed during charging is low, and the amount of water evaporation is also low. With the sealed structure of the housing, the sulfuric acid gas released is also Few, so compared with traditional batteries, it has no need to add any liquid, less corrosion to the wiring pile head, wires and body, anti-overcharging ability, large starting current, long storage time, etc., in recent years China is very popular. No matter what type of battery, it will slowly discharge itself until it is scrapped. Therefore, a car should be started at regular intervals to charge the battery. Another way is to unplug the two electrodes on the battery. It is important to note that the positive and negative electrode wires are unplugged from the electrode post. Unplug the negative wire first, or remove the connection between the negative electrode and the car chassis. Then pull the other end with the positive sign (X). The battery has a certain service life, and it must be replaced in a certain period. At the same time, the above sequence must be followed. However, when the electrode wire is connected, the order is the opposite. Connect the positive electrode first, and then connect the negative electrode.

The storage capacity of the battery can be reflected on the dashboard. When the current meter pointer shows insufficient power, charge it in time. Sometimes it is found that there is not enough electricity on the road, and the engine can't turn off and start. As a temporary measure, you can ask other vehicles for assistance. Use the batteries on their vehicles to start the vehicle. The negative and negative electrodes of the two batteries are connected, and the positive and negative electrodes are connected. .

When starting the car, the uninterrupted use of the start-up opportunity causes the battery to be damaged due to excessive discharge. The correct way to use it is that the total length of time for each vehicle is less than 5 seconds, and the interval for starting again is not less than 15 seconds. In the case of a car that has not been started for many times, the cause should be found in other aspects such as a circuit, an ignition coil or an oil circuit.

For wet batteries (lead-acid batteries), the density of electrolyte should be adjusted according to different regions and seasons. Distilled water or special rehydration solution should be supplemented at the time of deficient electrolyte, and it should not be replaced by pure drinking water, because pure water contains many trace elements, which will cause adverse effects on the storage battery. In addition, the daily operation should always check the small hole on the battery cover is vented, if the battery cover hole is blocked, the resulting hydrogen and oxygen can not be discharged, the electrolyte expansion, the battery casing will burst, affecting the battery life. Finally, you should always check whether the positive and negative electrodes of the battery are oxidized or not, and if possible, use hot water to often place the wire connections of the battery.

Filling and Seaming Machine

Filling Seaming Machine,Soft Drink Filling Machine,Can Filling Seaming Machine,Aluminum Filling Seaming Machine

Zhoushan Wellman Machinery Technology Co., Ltd.   , https://www.zhoushanwillman.com